Connecting To The Console Serial Port - Cisco AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge Hardware Installation Manual
Wireless outdoor access point/bridge
Hide thumbs
Also See for AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge:
- Datasheet (15 pages) ,
- Hardware installation manual (146 pages)
Table of Contents
Advertisement
Obtaining the Autonomous Access Point/Bridge Image File
Connecting to the Console Serial Port
If you need to configure the access point locally (without connecting to a wired LAN), you can connect
a PC to the power injector console serial port. Follow these steps to open the CLI by connecting to the
console serial port:
Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial console port on the power
Step 1
injector and to the COM port on your PC.
connector.
Figure 4-3
1
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
Note
http://www.cisco.com/go/marketplace
Step 2
Set up a terminal emulator to communicate with the access point. Use the following settings for the
terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
When the terminal emulator is activated, press Enter.
Step 3
Step 4
At the prompts, enter the administrator username and password. The default username is Cisco and the
default password is Cisco. The username and password are case sensitive.
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
4-14
Console Serial Port Connector
Console serial port connector (RJ-45 connector)
Chapter 4
Troubleshooting Autonomous Access Points and Bridges
Figure 4-3
shows the power injector's console serial port
1
to order a serial cable.
OL-5048-06
Advertisement
Table of Contents
