Cisco QuickVPN - PC Administration Manual page 190
Wireless-n gigabit security router with vpn
Hide thumbs
Also See for QuickVPN - PC:
- Administration manual (244 pages) ,
- User manual (112 pages) ,
- Administration manual (200 pages)
Table of Contents
Advertisement
Troubleshooting
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
STEP 4
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
Make sure the cable connecting from your cable or DSL modem is connected to
the router's Internet port. Verify that the Status page of the router's web-based
utility shows a valid IP address from your ISP.
Turn off the computer, router, and cable/DSL modem. Wait 30 seconds, and then
turn on the router, cable/DSL modem, and computer. Check System > Summary
from the router's web-based utility to see if you get an IP address.
I am not able to access the router's web-based utility Setup window.
Refer to
"I want to test my Internet connection.," on page 188
computer is properly connected to the router.
Verify that your computer has an IP Address, Subnet Mask, Gateway, and DNS.
Set a static IP address on your system; refer to
on a PC." on page 186
Refer to
"I am a PPPoE user and I need to remove the proxy settings or the
dial-up pop-up window.," on page
I can't get my Virtual Private Network (VPN) to work through the router.
Access the router's web interface by going to http://192.168.1.1 or the IP
address of the router, and go to VPN > VPN Pass Through. Make sure you have
IPSec passthrough and/or PPTP passthrough enabled.
VPNs that use IPSec with the ESP (Encapsulation Security Payload known as
protocol 50) authentication will work fine. At least one IPSec session will work
through the router; however, simultaneous IPSec sessions may be possible,
depending on the specifics of your VPNs.
VPNs that use IPSec and AH (Authentication Header known as protocol 51) are
incompatible with the router. AH has limitations due to occasional incompatibility
with the NAT standard.
Change the IP address for the router to another subnet to avoid a conflict between
the VPN IP address and your local IP address. For example, if your VPN server
assigns an IP address 192. 1 68. 1 .X (X is a number from 1 to 254) and your local
LAN IP address is 192. 1 68. 1 .X (X is the same number used in the VPN IP address),
the router will have difficulties routing information to the right location. If you
change the router's IP address to 192. 1 68.2. 1 , that should solve the problem.
above.
194.
to verify that your
"I need to set a static IP address
A
190
Advertisement
Table of Contents
