Cisco QuickVPN - PC Administration Manual page 117
Wireless-n gigabit security router with vpn
Hide thumbs
Also See for QuickVPN - PC:
- Administration manual (244 pages) ,
- User manual (112 pages) ,
- Administration manual (200 pages)
Table of Contents
Advertisement
Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the VPN Settings
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
Configure the settings in the following sections of the VPN > IPSec VPN window:
•
"Setting Up Local Groups" on page 118
•
"Setting Up and Configuring Remote Groups" on page 119
•
"Setting Up IPSec" on page 121
To configure advanced settings, click Advanced.
•
Aggressive Mode—There are two types of Phase 1 exchanges: Main mode
and Aggressive mode. Aggressive Mode requires half of the main mode
messages to be exchanged in Phase 1 of the SA exchange. If network
security is preferred, select Main mode.
•
NetBIOS broadcast—Check the box to enable NetBIOS traffic to pass
through the VPN tunnel. By default, WRVS4400N blocks these broadcasts.
Click Save.
To establish a connection for the current VPN tunnel, click Connect.
To break the connection, click Disconnect.
To view the VPN log, which shows details of each tunnel established, click View
Log.
5
117
Advertisement
Table of Contents
