Table of Contents
Advertisement
Chapter 4
Maintenance and Upgrade Procedures
Table 4-8
Table 9
Model
Cisco ASA 5520
Cisco ASA 5540
Removing and Installing the DIMM
This section describes how to remove and install the memory module on the adaptive security appliance.
This section includes the following topics:
•
•
Removing the DIMM
To remove the memory module, perform the following steps:
Power off the adaptive security appliance.
Step 1
Remove the power cord and other cables from the adaptive security appliance.
Step 2
Remove the adaptive security appliance from the rack if it is rack-mounted.
Step 3
Step 4
Place the adaptive security appliance in an ESD-controlled environment. See the
Environment" section on page 4-3
Step 5
Remove the adaptive security appliance cover. See the
section on page 4-1
Determine the location of the memory sockets. See
Step 6
for the Cisco ASA 5520 or Cisco ASA 5540.
Note
78-17989-01
lists the memory for the Cisco ASA 5520 and Cisco ASA 5540.
Memory Upgrade
Current Memory
512 MB
1 GB
Removing the DIMM, page 4-25
Installing the DIMM, page 4-28
for the procedure.
Some Cisco ASA 5510 have only a single memory socket, see
four memory sockets. In both cases, remove the existing DIMM, and replace it with the new
one. For memory upgrade in the Cisco ASA 5510 with four memory sockets, use slot 1 - P13 and
note that only one slot must be populated at all times.
Upgrading Memory in the Adaptive Security Appliance
Upgrade to
2 GB
2 GB
for more information.
"Removing and Replacing the Chassis Cover"
Figure 4-26
Cisco ASA 5500 Series Hardware Installation Guide
"Working in an ESD
for the Cisco ASA 5510 and
Figure
4-26. while others have
Figure 4-27
4-25
Hide quick links:
Advertisement
Table of Contents
