Table of Contents
Advertisement
Chapter 31
Configuring Network Security with ACLs
Command
Step 3
deny {source [source-wildcard] | host source |
any} [log]
or
permit {source [source-wildcard] | host source
| any} [log]
Step 4
end
Step 5
show access-lists [number | name]
Step 6
copy running-config startup-config
To remove a named standard ACL, use the no ip access-list standard name global configuration
command.
Beginning in privileged EXEC mode, follow these steps to create an extended ACL using names:
Command
Step 1
configure terminal
Step 2
ip access-list extended name
Step 3
{deny | permit} protocol {source
[source-wildcard] | host source | any}
{destination [destination-wildcard] | host
destination | any} [precedence precedence]
[tos tos] [established] [log] [time-range
time-range-name]
Step 4
end
Step 5
show access-lists [number | name]
Step 6
copy running-config startup-config
To remove a named extended ACL, use the no ip access-list extended name global configuration
command.
When you are creating standard extended ACLs, remember that, by default, the end of the ACL contains
an implicit deny statement for everything if it did not find a match before reaching the end. For standard
ACLs, if you omit the mask from an associated IP host address access list specification, 0.0.0.0 is
assumed to be the mask.
OL-8915-03
Purpose
In access-list configuration mode, specify one or more conditions
denied or permitted to decide if the packet is forwarded or dropped.
host source—A source and source wildcard of source 0.0.0.0.
•
any—A source and source wildcard of 0.0.0.0
•
255.255.255.255.
Return to privileged EXEC mode.
Show the access list configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Define an extended IPv4 access list using a name, and enter
access-list configuration mode.
The name can be a number from 100 to 199.
In access-list configuration mode, specify the conditions allowed
or denied. Use the log keyword to get access list logging messages,
including violations.
See the
"Creating a Numbered Extended ACL" section on
page 31-10
for definitions of protocols and other keywords.
host source—A source and source wildcard of source 0.0.0.0.
•
host destination—A destination and destination wildcard of
•
destination 0.0.0.0.
any—A source and source wildcard or destination and
•
destination wildcard of 0.0.0.0 255.255.255.255.
Return to privileged EXEC mode.
Show the access list configuration.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring IPv4 ACLs
31-15
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
