Table of Contents
Advertisement
Chapter 6
Configuring SDM Templates
Table 6-2
Resource
Unicast MAC addresses
IPv4 IGMP groups and multicast routes
Total IPv4 unicast routes:
•
•
IPv6 multicast groups
Total IPv6 unicast routes:
•
•
IPv4 policy-based routing ACEs
IPv4 or MAC QoS ACEs (total)
IPv4 or MAC security ACEs (total)
IPv6 policy-based routing ACEs
IPv6 QoS ACEs
IPv6 security ACEs
1. Not supported in the IP base image that runs on the switch.
2. The switch supports only input IPv6 router ACLs for management traffic.
Note
Although these features are visible in the template in the CLI, the switch does not support IPv4 or IPv6
policy-based routing or IPv6 Qos ACLs.
Configuring the Switch SDM Template
These sections contain this configuration information:
•
•
•
Default SDM Template
The default template is the default.
OL-8915-03
Approximate Feature Resources Allowed by Dual IPv4-IPv6 Templates
Directly connected IPv4 hosts
Indirect IPv4 routes
Directly connected IPv6 addresses
Indirect IPv6 unicast routes
1
2
Default SDM Template, page 6-3
SDM Template Configuration Guidelines, page 6-4
Setting the SDM Template, page 6-4
IPv4-and-IPv6
Default
2 K
1 K
3 K
2 K
1 K
1.125 K
3 K
2 K
1 K
1
0
0.75 K
1 K
1
0
0.5 K
0.5 K
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring the Switch SDM Template
IPv4-and-IPv6
IPv4-and-IPv6
Routing
VLAN
1.5 K
8 K
1K
1 K
2.75 K
0
1.5 K
0
1.25 K
0
1.125 K
1.125 K
2.75 K
0
1.5 K
0
1.25 K
0
0.25 K
0
0.75 K
0.75 K
0.5 K
1K
0.25 K
0
0.5 K
0.5 K
0.5 K
0.5 K
6-3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
