Table of Contents
Advertisement
Default Settings After Initial Switch Configuration
Monitoring Features
These are the monitoring features:
•
•
•
•
•
•
•
•
•
•
•
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation, requiring only that you assign basic IP information
to the switch and connect it to the other devices in your network. If you have specific network needs,
you can change the interface-specific and system-wide settings.
For information about assigning an IP address by using the browser-based Express Setup program, see
Note
the getting started guide. For information about assigning an IP address by using the CLI-based setup
program, see the hardware installation guide.
If you do not configure the switch at all, the switch operates with these default settings:
•
•
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
1-10
Switch LEDs that provide port- and switch-level status
MAC address notification traps and RADIUS accounting for tracking users on a network by storing
the MAC addresses that the switch has learned or removed
Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) for traffic monitoring on any port or
VLAN (except for the fa0 interface)
SPAN and RSPAN support of Intrusion Detection Systems (IDS) to monitor, repel, and report
network security violations
Four groups (history, statistics, alarms, and events) of embedded RMON agents for network
monitoring and traffic analysis
Syslog facility for logging system messages about authentication or authorization errors, resource
issues, and time-out events
Layer 2 traceroute to identify the physical path that a packet takes from a source device to a
destination device
Time Domain Reflector (TDR) to diagnose and resolve cabling problems on 10/100/1000 copper
Ethernet ports
SFP module diagnostic management interface to monitor physical or operational status of an SFP
module
Generic online diagnostics to test hardware functionality of the supervisor engine, modules, and
switch while the switch is connected to a live network.
Enhanced object tracking for HSRP.
Default switch IP address, subnet mask, and default gateway is 0.0.0.0. The fa0 interface might
receive an IP Address from the DHCP server. For more information, see
Switch IP Address and Default Gateway,"
Source Guard."
Default domain name is not configured. For more information, see
IP Address and Default Gateway."
and
Chapter 20, "Configuring DHCP Features and IP
Chapter 3, "Assigning the Switch
Chapter 1
Overview
Chapter 3, "Assigning the
OL-8915-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
