Table of Contents
Advertisement
Configuring VLANs
This chapter describes how to configure normal-range VLANs (VLAN IDs 1 to 1005) and
extended-range VLANs (VLAN IDs 1006 to 4094) on the switch. It includes information about VLAN
membership modes, VLAN configuration modes, VLAN trunks, and dynamic VLAN assignment from
a VLAN Membership Policy Server (VMPS).
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
The chapter consists of these sections:
•
•
•
•
•
•
Understanding VLANs
A VLAN is a switched network that is logically segmented by function, project team, or application,
without regard to the physical locations of the users. VLANs have the same attributes as physical LANs,
but you can group end stations even if they are not physically located on the same LAN segment. Any
switch port can belong to a VLAN, and unicast, broadcast, and multicast packets are forwarded and
flooded only to end stations in the VLAN. Each VLAN is considered a logical network, and packets
destined for stations that do not belong to the VLAN must be forwarded through a router or a switch
supporting fallback bridging, as shown in
network, it contains its own bridge Management Information Base (MIB) information and can support
its own implementation of spanning tree. See
Before you create VLANs, you must decide whether to use VLAN Trunking Protocol (VTP) to maintain
Note
global VLAN configuration for your network. For more information on VTP, see
"Configuring VTP."
OL-8915-03
Understanding VLANs, page 11-1
Configuring Normal-Range VLANs, page 11-4
Configuring Extended-Range VLANs, page 11-12
Displaying VLANs, page 11-16
Configuring VLAN Trunks, page 11-16
Configuring VMPS, page 11-27
C H A P T E R
Figure
11-1. Because a VLAN is considered a separate logical
Chapter 16, "Configuring STP."
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
11
Chapter 12,
11-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
