This completes the procedure for installing the chassis in a two-post rack. Proceed to the
Brackets" section on page 9
Attach the Cable-Management Brackets
The cable-management brackets for the Cisco ASR 1002-F Router contain one independent cable-management "U" feature with
two screws for each bracket. For the Cisco ASR 1000 Series SIP, these brackets work in tandem with SPA cable-management
brackets to allow installation and removal of adjacent SPAs without the need to remove cables.
Make certain that the cable-management bracket "U" feature (open end) is facing upwards when you attach it to the
Note
chassis.
Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1002-F Router in the rack:
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1002-F Router. The
Step 1
cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
Note
Use the package of four screws that came with the cable-management bracket package.
Insert one screw through the top screw hole of the cable-management bracket and into the chassis rack-mount bracket
Step 2
and tighten the screw using a Phillips screwdriver.
Figure 6
Attaching the Cable-Management Brackets to the Cisco ASR 1002-F Router
3
1
Cable-management bracket bottom screw hole and top
screw hole
Cable-management "U" feature
2
Step 3
Insert one screw through the bottom screw hole of the cable-management bracket and into the chassis rack-mount
bracket and tighten the screw using a Phillips head screwdriver.
to the chassis.
Step 4
Repeat Step 1 through Step 3 for the other side of the Cisco ASR 1002-F Router.
to continue the installation.
0
1
S
C3 -PO
SP A-4 XO
3
Chassis front rack-mount bracket
Figure 6
shows the cable-management brackets attached
"Attach the Cable-Management
2
9