Attach The Rack-Mount Brackets-Chassis Rear-Mounted; Four-Post Rack Installation - Cisco ASR1002 - ASR 1002 Router Quick Start Manual

Quick start guide

Hide thumbs Also See for ASR1002 - ASR 1002 Router:

Table of Contents

To install the cable-management bracket, see the

Step 6

Attach the Rack-Mount Brackets—Chassis Rear-Mounted

To install the rack-mount bracket on a Cisco ASR 1002-F Router for a rear rack-mount configuration, follow these steps:

Align the rack-mount bracket to the side of the router and locate the threaded ear holes in the rear sides of the chassis.

Step 1

Step 2

Position the rear rack-mount bracket top hole with the chassis from the back (See

the rear rack-mount bracket with the ear holes facing outward and towards the rear of the chassis.

Figure 3

Attaching the Cisco ASR 1002-F Router Rear Rack-Mount Brackets

Rear rack-mount bracket ear and holes

Rear rack-mount bracket

Step 3

Insert and tighten the screws.

Repeat Step 1 through Step 3 on the other side of the chassis.

Step 4

This completes the procedure for attaching rear rack-mount brackets to the chassis. Continue to the section Four-Post Rack

Installation, page 5 or the section Two-Post Rack Installation, page 7.

To install the chassis in a four-post rack, read the notes before you begin and then follow the steps listed in this section.

Note

Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches (48.26 cm).

Note

We recommend that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between the router and any

equipment directly above and below it.

Figure 4

shows the Cisco ASR 1002-F Router in a four-post rack.

"Attach the Cable-Management Brackets" section on page

Rear rack-mount bracket screws

Figure

3). Make certain that you hold

Table of Contents

Asr 1002-f