Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Yamaha YHT-17
Summary of Contents for Yamaha YHT-17
- Page 1 YHT-17 QUICK-CONNECT GUIDE...
-
Page 3: Tools And Parts
In addition to enhancing the sound of a video source, like your TV, DVD, or VCR, the YHT-17 also superbly reproduces audio sources, such as a CD player or a cassette deck. -
Page 4: Audio Components
YHT-17 Q Yamaha HTR-5230 Receiver (Rear Panel) NOTE: For your convenience, the Yamaha HTR-5230 receiver is equipped with two switched AC outlets (100 W max.). If desired, use them to power on connected components (e.g., CD player or turntable) each time the receiver is turned on. - Page 5 YHT-17 S ONNECTING NS-A16 SW-201 (Front Right Ch.) (Subwoofer) Clear/ Clear Stripe Wire To AC Outlet Wire Yamaha HTR-5230 A/V Receiver (Rear Panel Speaker Terminals) Clear/Stripe Clear Wire Wire Clear/Stripe NS-A16 (Surround Right) (Center Channel) YHT-17 Q PEAKERS ASIC Subwoofer Wiring...
- Page 6 YHT-17 S ONNECTING NS-A16 SW-201 (Front Right Ch.) (Subwoofer) POWER STANDBY-RED ON-GREEN AUTO STANDBY HIGH INPUT2 INPUT1 FROM AMPLIFIER OUTPUT TO SPEAKERS Clear/ Clear Stripe Wire To AC Outlet Wire Yamaha HTR-5230 A/V Receiver (Rear Panel Speaker Terminals) Clear/Stripe Clear...
- Page 7 INPUT1 FROM AMPLIFIER OUTPUT TO SPEAKERS ❶ To AC Outlet YHT-17 Q SW-201 S UBWOOFER 4. Play an audio source and adjust the HTR-5230’s VOLUME control to a desired listening level. 5. On the SW-201, increase the volume gradually to adjust the balance the volume between the SW-201 Subwoofer and the NS-A16 Main Speakers.
-
Page 8: Satellite Receiver
IDEO OMPONENTS Yamaha HTR-5230 Receiver (Rear Panel) NOTE: When using a hi-fi stereo VCR, set the Tuner/Line switch (on the VCR) to Line position to record from another source connected to the Yamaha HTR-5230 receiver. VIDEO SIGNAL VIDEO DVD/LD SAT/D-TV... - Page 9 RCA Cable Color Codes Yellow = Video White = Left Audio Red = Right Audio YHT-17 Q Yamaha HTR-5230 Receiver (Rear Panel) Use an RCA Video Cable And Jacks For Video Interconnections DVD/LD U I C K O N N E CT...
- Page 10 MD recorder, or VCR. To record programs from a source (e.g., laserdisc player), connect the source unit to the DVD/LD (or SAT/D-TV) AUDIO SIGNAL input terminals. Yamaha HTR-5230 Receiver (Rear Panel) DVD/LD Video Out Audio L Out...
- Page 11 IDEO OMPONENTS Yamaha HTR-5230 Receiver (Rear Panel) NOTE: When using a hi-fi stereo VCR, set the Tuner/Line switch (on the VCR) to Line position to record from another source connected to the Yamaha HTR-5230 receiver. AUDIO SIGNAL DVD/LD SAT/D-TV Use RCA Audio Cables And Jacks For Audio Interconnections...
- Page 12 ABLE ASIC NOTE: When using a hi-fi stereo VCR, set the Tuner/Line switch (on the VCR) to Line position to record from another source connected to the Yamaha HTR-5230 receiver. ANT In Basic Cable (From Wall Jack) Descrambler Premium Cable...
- Page 13 To Enter Setup Codes Use To Enter Setup Mode The YHT-17 Home Theater package includes a univer- sal remote control. It comes pre-programmed with factory codes to control your HTR-5230 receiver and most Yamaha audio components. To program other brands of components (i.e., TV, VCR, etc.) or if your Yamaha unit does not respond, you will need to program the remote control with the manufacturer’s...
- Page 14 5. To verify the code works, aim the remote control at the VCR, press VCR, and then press POWER. The VCR should turn off. If it doesn’t respond, use another code for the same manufacturer and repeat steps 3 through 5. YHT-17 Q EMOTE ONTROL ONTINUED ETTING 1.
-
Page 15: Playing A Dvd
> (forward button) to start play. NOTE: The DVD player’s controls are now assigned to the remote control buttons, since DVD was the last selected component. YHT-17 Q EMOTE ONTROL ESETTING You can reset the remote control to factory codes for... - Page 16 ©2000 YAMAHA ELECTRONICS CORPORATION, USA 6660 Orangethorpe Avenue, Buena Park, CA 90620 PH: (714) 522-9105; FAX: (888) 435-7922 http://www.yamaha.com...