Table of Contents
Advertisement
Pole Mounting the AP using the Meraki Kit
An audible click confirms that the AP is securely locked to the mounting bracket.
Note
Step 6
Tighten the mounting plate security screw.
Step 7
Proceed with installing antennas, connecting the data cables, grounding the AP, powering, and configuring
the AP.
Pole Mounting the AP using the Meraki Kit
The MA-MNT-MR-16 mounting kit contains a mounting bracket used for wall mounting and pole mounting.
This kit can be used to install the AP on a pole or mast. It supports metal, wood, or fiberglass poles of 2 to
3.9 inch (51 to 99.06 mm) in diameter.
Figure 8: AP Mounted on a Pole
Before you begin
Ensure that you have the following materials before beginning to mount the AP to a pole:
Table 6: Materials Needed to Mount the AP on a Vertical Pole using MA-MNT-MR-16 Kit
Materials Required
One wall mount bracket
Two stainless steel band clamps (adjustable 2 to 5 inch (51 to 127 mm)
10–mm box-end wrench
A flathead screwdriver
Outdoor-rated shielded Ethernet cable
Ground lug (provided with the access point)
Ground block and rod
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
22
The AP should be mounted with the status LED on the base facing downwards.
Installing the Access Point
Supplied in the
Kit?
Yes
Yes
No
No
No
Yes
No
Advertisement
Table of Contents
Troubleshooting
