Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZWHB 7130 P
Summary of Contents for Zanussi ZWHB 7130 P
- Page 1 User manual Washing Machine ZWHB 7130 P ZWHB 7160 P...
-
Page 2: Table Of Contents
• If the appliance has a child safety device, we recommend you acti- vate it. General Safety • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • Do not change the specification of this appliance. www.zanussi.com... -
Page 3: Safety Instructions
13 between the appliance and the carpet. amp ASTA (BS 1362) fuse. Electrical connection • Warning! Risk of fire and electrical shock. This appliance complies with the E.E.C. Di- rectives. • The appliance must be earthed. www.zanussi.com... -
Page 4: Frost Precaution
7. screw the water inlet hose to the tap and the drain hose to the rear of the appliance again; www.zanussi.com... -
Page 5: Environment Concerns
• Measure out detergent according to the wa- >PS<=polystyrene ter hardness, the degree of soiling and the >PP<=polypropylene quantity of laundry being washed. This means that they can be recycled by dis- posing of them properly in appropriate collec- tion containers. Product description www.zanussi.com... -
Page 6: Technical Data
Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1300 rpm (ZWHB 7130P) 1600 rpm (ZWHB 7160P) Installation Unpacking Warning! • Read carefully the "Safety information" chapter before installing the appliance. www.zanussi.com... - Page 7 • Remove the power supply cable and the draining and inlet hose from the hose hold- • Remove the cardboard top. ers on the rear of the appliance. • Remove the polystyrene packaging materi- als. www.zanussi.com...
- Page 8 Level the appliance by raising or lowering the feet. The appliance MUST be level and stable on a flat hard floor. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner. www.zanussi.com...
- Page 9 If the outlet spigot has not been used before, remove any blanking plug that may be in place. www.zanussi.com...
- Page 10 The appliance should be connected to the this water is discharged directly into a river or FOUL drainage system, the water will then be stream and may cause pollution. taken to a sewage works for treatment before being discharged safely into a river. www.zanussi.com...
-
Page 11: Special Accessories
Pour 1/2 a measure of deter- gent into the main wash compartment • Ensure that the drum is empty. and start the machine. • Before the first wash, run a cotton cycle at the highest temperature without any www.zanussi.com... -
Page 12: Personalisation
(e.g the stain; treat several times. curtains). Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. www.zanussi.com... - Page 13 • Cotton, linen: drum full but not too tightly on the type of fabric, load size, degree of soiling packed; and hardness of the water used. • Synthetics: drum no more than half full; 1) do not use acetone on artificial silk. www.zanussi.com...
- Page 14 Flap for powder or liquid detergent partment UP- Flap position if DOWN - Flap posi- using POWDER de- tion if using LIQ- The flap is up and you wish to use liquid tergent UID detergent dur- detergent: ing main wash www.zanussi.com...
- Page 15 When an option button is selected, the corresponding pilot light is on. Otherwise it is off. For compatibility among washing programmes and options, see the "Washing Programmes". If an incorrect option is selected, the integrated red pilot light of the button 9 flashes 3 times and the display shows the message Err. www.zanussi.com...
- Page 16 9 again. The water in the tub will be not emptied out. Temperature button 90° 60° 40° Push the temperature button to select the most suitable 30° temperature for washing your laundry . — cold wash www.zanussi.com...
- Page 17 Press simultaneously the buttons 4 and 6 for some seconds: • the pilot light of button 6 illuminates; • the extra rinse option is activated and it stays permanently To remove it press the same buttons again until the pilot light of button 6 goes off. www.zanussi.com...
- Page 18 The selected delay time value will appear on the display for a few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you start the programme. www.zanussi.com...
- Page 19 • To interrupt a programme which is running, press the but- ton 9: the corresponding green pilot light starts flashing. It is possible to change some options of a running programme before the programme carries them out. www.zanussi.com...
- Page 20 At the end of the programme, the door can be now opened. Turn the programme selector dial to switch the appliance off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry www.zanussi.com...
-
Page 21: Washing Programmes
Main wash - Rinses - Maximum spin speed at 900 rpm SUPER QUICK Max. load 3,5 kg - Reduced load 2 kg EXTRA RINSE Synthetic or mixed fabrics: underwear, coloured garments, DELAY START non-shrink shirts, blouses . Normally soiled items. www.zanussi.com... - Page 22 Separate spin for hand washed garments. You can reduce the spin speed by pressing the relevant button to adapt it to the fabrics to be spun. If a lower speed is selected, by pressing the relevant button, the appliance performs a short spin. www.zanussi.com...
-
Page 23: Consumption Values
3) The appliance performs the short heating phase if the water temperature is below 20 °C. The appliance shows the temperature setting as “Cold”. Consumption values The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. www.zanussi.com... -
Page 24: Care And Cleaning
To run a maintenance wash: • The drum should be empty of laundry. • Remove the drawer. • Select the hottest cotton wash programme. • Use a normal measure of detergent, must be a powder with biological properties. www.zanussi.com... - Page 25 The pump must be cleaned regularly. the right position To clean the filter, proceed as follows: again. • turn programme selector dial to position • open the filter cov- er and insert the fil- • unplug the appliance; ter again; • open the door; www.zanussi.com...
-
Page 26: What To Do If
Before contacting your local Service Centre, bed in the charts, without calling out an engi- please carry out the checks listed below. neer. During appliance operation it is possible that the red pilot light of the button 9 flashes, the www.zanussi.com... - Page 27 The door has not been closed or is not closed properly. • Close firmly the door. Door open The appliance does not start or stops during Before contacting your local Service Centre, operation without any visible alarm. please carry out the checks listed below. www.zanussi.com...
- Page 28 The appliance is not levelled correctly. The appliance vibrates • Adjust the feet. noisily: The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry. www.zanussi.com...
- Page 29 If the malfunction shows again, contact your Service Centre. The necessary data for the Model description (MOD.) ....... Product number (PNC) ........Serial number (S.N.) ........Mod..Prod. No..Ser. No..www.zanussi.com...
- Page 30 www.zanussi.com...
- Page 31 www.zanussi.com...
- Page 32 www.zanussi.com/shop...