Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZWH 7149 P
Summary of Contents for Zanussi ZWH 7149 P
- Page 1 User manual Washing Machine ZWH 7149 P...
-
Page 2: Table Of Contents
• If the appliance has a child safety device, we recommend you acti- vate it. General Safety • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • Do not change the specification of this appliance. www.zanussi.com... -
Page 3: Safety Instructions
Electrical connection • The appliance is to be connected to the wa- Warning! Risk of fire and electrical shock. ter mains using the new supplied hose-sets. Old hose sets must not be reused. • The appliance must be earthed. www.zanussi.com... -
Page 4: Frost Precaution
When you intend to start the appliance up 4. unscrew the drain hose from the rear sup- again, make sure that the room temperature is port and unhook it from sink or spigot; above 0°C. 5. place a bowl on the floor; www.zanussi.com... -
Page 5: Environment Concerns
• Measure out detergent according to the wa- >PS<=polystyrene ter hardness, the degree of soiling and the >PP<=polypropylene quantity of laundry being washed. This means that they can be recycled by dis- posing of them properly in appropriate collec- tion containers. Product description www.zanussi.com... -
Page 6: Technical Data
Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1400 rpm Installation Unpacking Warning! • Read carefully the "Safety information" chapter before installing the appliance. www.zanussi.com... - Page 7 Make sure that no hoses are crushed in the process. • Remove the polystyrene base from the bot- tom. www.zanussi.com...
- Page 8 Repeat the levelling action, if the appliance is not level and stable. • Plug the smaller upper hole and the two Warning! This appliance is free standing large ones with the corresponding plastic only. Do not remove the worktop for any plug caps. reason. www.zanussi.com...
- Page 9 The end of the drain hose can be positioned side diameter of the in four ways: drain hose. The drain • Hooked over the edge of a sink using hose must not be the plastic hose guide. kinked. www.zanussi.com...
- Page 10 It is essential that these appliances are not con- nected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution. If you require any further advice please contact your local water authority. www.zanussi.com...
-
Page 11: First Use
5 buttons simultane- vice, which sounds in the following cases: ously for about 6 sec- • at the end of the cycle; onds, the acoustic • if there is a fault. signal is deactivated (except if there is a fault). www.zanussi.com... -
Page 12: Daily Use
, then with acetic acid; treat any residual marks on white fabrics with • Wash the socks and the gloves inside the bleach and then rinse thoroughly. bag or a net. 1) do not use acetone on artificial silk. www.zanussi.com... - Page 13 When the degree of hardness is soft, readjust choice of detergent and use of the correct quantities to avoid waste and protect the envi- the quantity of the detergent. ronment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. www.zanussi.com...
- Page 14 The detergent must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. • Remove the drawer. Push the drawer edge outwards where indicated by the arrow (PUSH) to facilitate drawer removal. www.zanussi.com...
- Page 15 When an option button is selected, the corresponding pilot light is on. Otherwise it is off. For compatibility among washing programmes and options, see the "Washing Programmes". If an incorrect option is selected, the integrated red pilot light of the button 9 flashes 3 times and the display shows the message Err. www.zanussi.com...
- Page 16 Start the new programme by pressing the button 9 again. The water in the tub will be not emptied out. Temperature button Push the temperature button to select the most suita- ble temperature for washing your laundry . www.zanussi.com...
- Page 17 Press simultaneously the buttons 4 and 6 for some seconds: • the pilot light of button 6 illuminates; • the extra rinse option is activated and it stays permanently To remove it press the same buttons again until the pilot light of button 6 goes off. www.zanussi.com...
- Page 18 9 start flashing. • End of programme When the programme has finished a zero ( ) is displayed, the door pilot light 10 and the pilot light of button 9 go out and the door can be opened. www.zanussi.com...
- Page 19 PAUSE by pressing button 9 and wait a few minutes before opening the door. After you have closed the door, press the same button again. The Delay Start cannot be selected with the draining pro- gramme. www.zanussi.com...
- Page 20 If you do not intend to carry Follow the below instructions to empty out the out another wash, close the water tap. Leave water: the door open to prevent the formation of mil- • Turn the programme selector dial to dew and unpleasant smells. www.zanussi.com...
-
Page 21: Washing Programmes
Main wash - Rinses - Maximum spin speed 900 rpm DELAY START, Max. load 3,5 kg - Reduced load 2 kg SUPER QUICK Synthetic or mixed fabrics: underwear, coloured garments, EXTRA RINSE non-shrink shirts, blouses . Normally soiled items. www.zanussi.com... - Page 22 Main wash - Rinses - Maximum spin speed 900 rpm EXTRA RINSE, Max. load 3 kg DELAY START Highly energy efficient cold wash programme for lightly soiled laundry. This programme requires a detergent which is active in cold water. www.zanussi.com...
-
Page 23: Consumption Values
The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. Programmes Load Energy con- Water con- Approximate Remaining (kg) sumption sumption (litre) programme du- moisture (kWh) ration (mi- nutes) Cottons 60 °C Cottons 40 °C 0.85 Synthetics 40 °C 0.65 www.zanussi.com... -
Page 24: Care And Cleaning
• Select the hottest cotton wash programme. should be removed. • Use a normal measure of detergent, must be a powder with biological properties. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. www.zanussi.com... - Page 25 • turn programme selector dial to position • open the filter cov- • unplug the appliance; er and insert the fil- • open the door; ter again; • turn the drum and align the filter cover (FILTER) with the arrow on the door seal; www.zanussi.com...
-
Page 26: What To Do If
Before contacting your local Service Centre, bed in the charts, without calling out an engi- please carry out the checks listed below. neer. During appliance operation it is possible that the red pilot light of the button 9 flashes, the www.zanussi.com... - Page 27 The door has not been closed or is not closed properly. • Close firmly the door. Door open The appliance does not start or stops during Before contacting your local Service Centre, operation without any visible alarm. please carry out the checks listed below. www.zanussi.com...
- Page 28 The appliance is not levelled correctly. The appliance vibrates • Adjust the feet. noisily: The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry. www.zanussi.com...
- Page 29 If the malfunction shows again, contact your Service Centre. The necessary data for the Model description (MOD.) ....... Product number (PNC) ........Serial number (S.N.) ........Mod..Prod. No..Ser. No..www.zanussi.com...
- Page 30 www.zanussi.com...
- Page 31 www.zanussi.com...
- Page 32 www.zanussi.com/shop...