Table of Contents
Advertisement
Advertisement
Chapters
Table of Contents
Related Manuals for Zanussi ZWH 7120 P
Summary of Contents for Zanussi ZWH 7120 P
- Page 1 User manual Washing Machine ZWH 7120 P ZWH 7140 P ZWH 7160 P...
-
Page 2: Table Of Contents
Read ine spare parts. "Frost precaution". Installation General safety • This appliance is heavy. Care should be tak- • It is dangerous to alter the specifications or en when moving it. attempt to modify this product in any way. www.zanussi.com... - Page 3 • Children should be supervised to ensure that they do not play with the appliance. www.zanussi.com...
-
Page 4: Frost Precaution
For more detailed point for the recycling of electrical and information about recycling of this product, electronic equipment. By ensuring this product please contact your local council, your www.zanussi.com... -
Page 5: Product Description
Product description Detergent dispenser drawer Water drain hose Worktop Drain hose support Control panel Hose holders Door opening handle Water inlet hose Rating plate (on the inner edge) Mains cable Front adjustable feet Back feet www.zanussi.com... -
Page 6: Technical Data
0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1200 rpm (ZWH 7120 P) 1400 rpm (ZWH 7140 P) 1600 rpm (ZWH 7160 P) Installation Unpacking • Remove the exter- nal film. Use a cut- Warning! ter, if necessary. - Page 7 • Remove the power supply cable and the draining and inlet hose from the hose hold- ers on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. www.zanussi.com...
- Page 8 Repeat the levelling action, if the appliance is with the appliance . not level and stable. The end of the drain hose can be positioned in four ways: • Hooked over the edge of a sink using the plastic hose guide. www.zanussi.com...
- Page 9 • Directly into a drain pipe at a height of The drain hose may be extended to a maxi- not less than 60 cm and not more than mum of 4 metres. An additional drain hose 100 cm. and joining piece is available from your Local Centre. www.zanussi.com...
- Page 10 • Do not pull the mains cable to disconnect DISHWASHER MACHINE the appliance. Always pull the mains plug. RAINWATER ‘RUN-OFF’ • This appliance complies with the E.E.C. Di- rectives. FOUL DRAIN SURFACE WATER FOUL SEWERS DRAINS & SEWERS SEWAGE TREATMENT UNTREATED WORKS DISCHARGE TREATED DISCHARGE RIVER RIVER www.zanussi.com...
-
Page 11: First Use
Daily use Sort out the laundry Follow the wash code symbols on each gar- ment label and the manufacturer’s washing in- structions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. www.zanussi.com... - Page 12 Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). 1) do not use acetone on artificial silk. www.zanussi.com...
- Page 13 If the flap is not in the desired position: • large amounts of foam form during washing. Degrees of water hardness Water hardness is classified in so-called “de- grees” of hardness. Information on hardness of the water in your area can be obtained from the www.zanussi.com...
- Page 14 Any additives must detergent: be placed in the ap- • Rotate the flap propriate compart- downwards. ments of the dispens- • Carefully put the er drawer just before drawer back. starting the wash pro- gramme. Close the detergent dispenser drawer www.zanussi.com...
- Page 15 . Select the new programme by turning the selec- tor to the desired programme. Start the new programme by pressing the button 9 again. The water in the tub will be not emptied out. www.zanussi.com...
- Page 16 (extra rinse), select this option. Some additional rinses will be performed. This option is recommended for people who are allergic to de- tergents, and in areas where the water is very soft. www.zanussi.com...
- Page 17 9 start flashing. • End of programme When the programme has finished a zero ( ) is displayed, the door pilot light 10 and the pilot light of button 9 go out and the door can be opened. www.zanussi.com...
- Page 18 PAUSE by pressing button 9 and wait a few minutes before opening the door. After you have closed the door, press the same button again. The Delay Start cannot be selected with the draining programme. www.zanussi.com...
- Page 19 Follow the below instructions to empty out the the drum is empty. If you do not intend to carry water: out another wash, close the water tap. Leave www.zanussi.com...
-
Page 20: Washing Programmes
90°- Cold RINSE HOLD Prewash - Main wash - Rinses - Maximum spin speed at: 1200 rpm for model ZWH 7120 P; 1400 rpm for model ZWH SUPER QUICK 7140 P; 1600 rpm for model ZWH 7160 P EXTRA RINSE Max. -
Page 21: Synthetics 40
60° - Cold SPIN REDUCTION Main wash - Rinses - Maximum spin speed at: 1200 rpm for RINSE HOLD model ZWH 7120 P; 900 rpm for model ZWH 7140 P and SUPER QUICK for model ZWH 7160 P EXTRA RINSE Max. -
Page 22: Standard
JEANS 60°- Cold Main wash - Rinses - Maximum spin speed at 1200 rpm for model ZWH 7120 P; 900rpm for model ZWH 7140 P and for SPIN REDUCTION model ZWH 7160 P RINSE HOLD Max. load 3 kg... -
Page 23: Consumption Values
°C Wool/Hand wash 30 °C Standard cotton programmes Standard 60 1.07 °C cotton Standard 60 0.79 °C cotton Standard 40 0.57 °C cotton 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.65 0.65 www.zanussi.com... -
Page 24: Care And Cleaning
• turn programme selector dial to position additive compart- ment should be re- • unplug the appliance; moved. • open the door; • turn the drum and align the filter cov- er (FILTER) with the arrow on the door seal; www.zanussi.com... - Page 25 • Clean the filter in the valve with a stiff brush or with the piece of cloth. • Screw the hose back to the appliance and make sure the connection is tight. • Turn on the water tap. www.zanussi.com...
-
Page 26: What To Do If
• carry out the drain filter cleaning as described in "Cleaning the drain filter"; • at the end of cleaning action, close the door and insert the mains plug again; • run a drain programme to check if the appliance works now. www.zanussi.com... - Page 27 • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one. www.zanussi.com...
- Page 28 We recom- appliance and press the button 9 to restart the mend that you write the data here: programme. If the malfunction shows again, contact your Service Centre. The necessary data for the www.zanussi.com...
- Page 29 Model description (MOD.) ....... Product number (PNC) ........Serial number (S.N.) ........Mod..Prod. No..Ser. No..www.zanussi.com...
- Page 30 www.zanussi.com...
- Page 31 www.zanussi.com...
- Page 32 www.zanussi.com/shop...