Zanussi ZWH 6120 P User Manual
Hide thumbs
Also See for ZWH 6120 P:
- User manual (23 pages) ,
- User manual (32 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWH 6120 P
Summary of Contents for Zanussi ZWH 6120 P
- Page 1 User manual Washing Machine ZWH 6120 P ZWH 6140 P ZWH 6160 P...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4... - Page 3 not pressing the electrical supply cable against the • The detergent dispenser drawer is provided with an in- wall. sert for liquid detergent. Do not use the insert down- wards for gelatinous detergents, with programmes in- • Install the appliance on a flat hard floor. cluding prewash, with the delay start option.
-
Page 4: Frost Precaution
To activate this device, ro- To disable this device and tate the button (without restore the possibility of pressing it) inside the closing the door, rotate the door clockwise until the button anti-clockwise until groove is horizontal. If the groove is vertical. necessary use a coin. -
Page 5: Product Description
>PP<=polypropylene • The machine works more economically if it is fully loa- This means that they can be recycled by disposing of ded. them properly in appropriate collection containers. • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a Ecological hints lower temperature. -
Page 6: Installation
Electrical connection Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1200 rpm (ZWH 6120P) 1400 rpm (ZWH 6140P) 1600 rpm (ZWH 6160P) Installation... - Page 7 • Return appliance to it's • Unscrew the three bolts (A) and remove the hose upright position. holders (C). • Slide out the relevant plastic spacers (B). Warning! Do not re- move the drain hose from the rear support. Re- move this hose only if it is necessary to drain the wa- •...
- Page 8 Positioning and levelling 35° 45° Loosen the ring nut to angle the hose to the left or right depending on the position of your water tap. Do not place the inlet hose downwards. After positioning the inlet hose, be sure to tighten the ring nut again to pre- vent leaks.
- Page 9 If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe. • Directly to a built-in drain pipe in the room wall. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose to pre- vent waste from the sink entering the appliance.
-
Page 10: First Use
In the interest of the environment Electrical connection The appliance should be connected to the FOUL drainage • The appliance must be earthed. system, the water will then be taken to a sewage works for • Make sure that the electrical information on the rating treatment before being discharged safely into a river. - Page 11 Before Loading The Laundry Ink: depending on the type of ink, moisten the fabric first with acetone , then with acetic acid; treat any residual Important! Make sure that marks on white fabrics with bleach and then rinse thor- no metal objects are left in oughly.
- Page 12 Although biodegradable, detergents contain substances Warning! If you wish to carry out the prewash, pour which, in large quantities, can upset the delicate balance the detergent among washing items into the drum. of nature. Warning! Depending on the type detergent you use The choice of detergent will depend on the type of fabric (powder of liquid), ensure that the flap, placed in the (delicates, woollens, cottons, etc.), the colour, washing...
- Page 13 Warning! Do not use the flap in "DOWN" position • Measure out the deter- with: gent. • Gelatinous detergent or thick detergent. • Pour the powder deter- • Powder detergent. gent into the main wash • With programmes with prewash. compartment •...
-
Page 14: Controls
Programme selector dial Turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 6 starts flashing: the appliance is now switched on. Specials Jeans Cottons Cottons If you turn the programme selector dial to another programme when... - Page 15 Automatic Spin reduction and By selecting a programme, the appliance proposes automatically the maxi- Rinse Hold mum spin speed provided for that programme. By selecting Automatic Spin reduction ( ) the spin speed is reduced to a half, but not less than 400 rpm. The relevant light illuminates. Rinse Hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing.
-
Page 16: At End Of Programme
Important! The selected delay can be changed only after selecting the wash- ing programme again. The door will be locked throughout the delay time. If you need to open the door, you must set the appliance to PAUSE (by press- ing the button 6) and then wait a few minutes. -
Page 17: Washing Programmes
another wash, close the water tap. Leave the door open to Door seal prevent the formation of mildew and unpleasant smells. At the end of every cycle, Warning! If there are children or pets in the house, check from the door seal activate the child safety device in the inner side of and remove objects that the door frame (for more details read "... - Page 18 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry SYNTHETICS AUTOMATIC SPIN RE- 60° - Cold DUCTION Main wash - Rinses - Maximum spin speed at 1200 rpm RINSE HOLD Max.
- Page 19 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry SPIN Drain and long spin at maximum spin speed: 1200 rpm for model ZWH 6120P; 1400 rpm for model ZWH 6140P; 1600 rpm for model ZWH 6160P AUTOMATIC SPIN RE- Max.
-
Page 20: Consumption Values
Consumption values Programme Energy consumption Water consumption Programme duration (KWh) (litre) (Minutes) White Cottons 90 °C Cottons 60 °C Cottons 40 °C 0.85 Synthetics 40 °C 0.65 Delicates 40 °C 0.65 Wool/ Handwash 30 °C 1) The consumption information shown in this chart is indicative. It can vary depending on the quantity and the type of laundry, on the temperature of the water supply and on the ambient temperature. - Page 21 • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open un- til the filter removal. • before removing the fil- • Use a stiff brush to clean and remove all washing ter, remove any fluff or powder residue.
-
Page 22: What To Do If
display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. - Page 23 The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked • Clean the water inlet filters (read "Cleaning the water inlet filters" for more details). The light of button 6 flashes and the light 7.2 illuminates: Problem with the water drainage The drain hose is squashed or kinked.
- Page 24 Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. The appliance does not start: •...
- Page 25 Malfunction Possible cause / Solution The electronic unbalance detection device has cut in because the laundry is not even- ly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
- Page 28 www.zanussi.com/shop...