Performing A Preinstallation Configuration (Optional) - Cisco Catalyst 9124AX Series Hardware Installation Manual
Outdoor access point
Hide thumbs
Also See for Catalyst 9124AX Series:
- Hardware installation manual (118 pages) ,
- Installation manual (118 pages)
Table of Contents
Advertisement
Installation Overview
Performing a Preinstallation Configuration (Optional)
Performing a Preinstallation Configuration (Optional)
Performing the following procedures ensure that the AP installation and the initial operation proceed as
expected. This procedure is optional.
Note
If your wireless controller is configured properly, you can install the AP in its final location and connect it to
the network from there. For additional information, see
Deploying the Access Point in a Wireless Network,
on page
62.
The preinstallation configuration setup is illustrated in
Figure 24: Preinstallation Configuration Setup, on page
22:
Figure 24: Preinstallation Configuration Setup
To perform preinstallation configuration, follow these steps:
Procedure
Step 1
Ensure that the Cisco Controller Distribution System port is connected to the network. Use the procedure for
the CLI or the GUI interface, as described in the release appropriate Cisco Controller Configuration guide.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
22
- Quick Links:
- Power Sources
- Choosing a Mounting Kit
Hide quick links:
Advertisement
Table of Contents
