Hardware Features
• Power over Ethernet (PoE): For more information, see
Danger
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950 based safety standards. Statement 1033
Caution
For PoE options and their corresponding modes of operation, see
Reduced Power Feature Matrix, on page
Caution
When the AP is installed outdoors or in a wet or damp location, the AC branch circuit powering the AP should
be provided with ground fault protection (GFCI), as required by Article 210 of the National Electrical Code
(NEC).
Power Injectors
The Cisco Catalyst 9124AX Series Outdoor Access Point supports the following power injectors:
• AIR-PWRINJ-60RGD1=
• AIR-PWRINJ-60RGD2=
• AIR-PWRINJ6=
• AIR-PWRADPT-RGD2=
Danger
To reduce the risk of fire, use only No. 24 AWG or larger telecommunications line cord. Statement 1023
Caution
When the AP is installed outdoors or in a wet or damp location, the AC branch circuit powering the AP should
be provided with ground fault protection (GFCI), as required by Article 210 of the National Electrical Code
(NEC).
Ethernet (PoE) Ports
The AP supports an Ethernet uplink port (also for PoE-In). The Ethernet uplink port on the AP uses an RJ-45
connector (with weatherproofing) to link the AP to the 100BASE-T, 1000BASE-T, or 2.5GBASE-T network.
The Ethernet cable is used to send and receive Ethernet data and optionally supply inline power from the
power injector or a suitably powered switch port.
50.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Powering the Access Point, on page
Table 11: Cisco Catalyst 9124AX AP
Power Injectors
50.
13