Cisco Catalyst 9124AX Series Hardware Installation Manual page 62

Outdoor access point

Hide thumbs Also See for Catalyst 9124AX Series:

Table of Contents

Connecting a DC Power Cable to the Access Point

Figure 50: Terminating DC plug to the cable

DC 2-conductor 18 AWG cable

Crimp Pins

Seal Nut

Figure 51: Wire Stripping Length

cable

a) Dis-assemble the DC plug .

b) Pass the cable through the plug components.

c) Strip the cable end.

Note

d) Insert wire conductor into crimp pins. Using a 0.10 inch (2.54 mm) Hex crimp tool, crimp the pin to the

wire to secure it in place. Repeat for the second pin. If you must re-do the crimping process, you can use

the 2 extra pins supplied.

e) Insert the crimped pins and wire into the female barrel of the connector body. Be sure to insert the proper

wire polarity into the corresponding barrel shown on the body. Push to be sure the pin is fully seated into

the barrel.

Note

f) Slide the gasket and seal the ring down the cable, thread the ring on to the body. Use caution to be sure

the gasket is correctly seated into the ring. Hand tighten to seal gasket fully.

Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide

Remove the wire jacket and tin the wire strands. Tinning the strands helps to insert the wire

into the crimp pins.

Pin 1 (+V) Pin 2 (-V), the connector body is marked (+) and (-) to show polarity pin assignments.

Grommet and Seal Ring

Gasket

Connector body

Installation Overview

Table of Contents

Show Quick Links

Table of Contents