Table of Contents
Advertisement
Tools and Parts Required
You need the following tools and parts to install a port adapter. If you need additional equipment,
contact a service representative for ordering information.
•
PA-5EFL(=) port adapter and one of the following:
— VIP2-15(=), VIP2-20=, VIP2-40(=) or VIP2-50(=)
— Cisco 7200 series router with at least one available port adapter slot
•
Cables appropriate for the port adapter interfaces (ST-type optical-fiber cables are not available
from Cisco Systems; they are available from outside commercial cable vendors.)
•
Number 1 Phillips and a 3/16-inch, flat-blade screwdriver.
•
Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, FRUs, and spares.
Software and Hardware Requirements
Table 1
Router Platform
Cisco 7000 series and Cisco 7500 series
• With VIP2-15 or VIP2-40
• With VIP2-50
Cisco 7200 series
• Cisco 7204VXR and Cisco 7206VXR
• Cisco 7204 and Cisco 7206
• Cisco 7202
In the Cisco 7000 series or Cisco 7500 series routers, the 5EFL port adapter requires the following
VIP2 models:
•
VIP2-15 (1 MB of SRAM, 8 MB of DRAM)
•
VIP2-20 (1 MB of DRAM, 16 MB of SRAM)
•
VIP2-40 (2 MB of SRAM, 32 MB of DRAM)
•
VIP2-50 (4 to 8 MB of SRAM, 32 to 128 MB of DRAM)
Caution
and RSP7000CI installed. The VIP2 will not operate properly with the Route Processor (RP), Switch
Processor (SP), or Silicon Switch Processor (SSP) installed in the Cisco 7000 series router.
PA-5EFL Port Adapter Software Requirements
Minimum Cisco IOS Release
Cisco IOS Release 11.1(472) or a later release of Cisco IOS Release 11.1
Cisco IOS Release 11.1(6)CA or a later release of Cisco IOS Release 11.1 CA
Cisco IOS Release 11.2(1) or a later release of Cisco IOS Release 11.2
Cisco IOS Release 11.2(6)P or a later release of Cisco IOS Release 11.1 P
Cisco IOS Release 11.1(14)CA or a later release of Cisco IOS Release 11.1 CA
Cisco IOS Release 11.1(14)CA or a later release of Cisco IOS Release 11.1 CA
Cisco IOS Release 12.0(3)T or a later release of Cisco IOS Release 12.0 T
Cisco IOS Release 12.0(2)XE2 or a later release of Cisco IOS Release 12.0 XE
Cisco IOS Release 11.1(9)CA1 or a later release of Cisco IOS Release 11.1 CA
Cisco IOS Release 11.1(19)CC1 or a later release of Cisco IOS Release 11.1 C
Cisco IOS Release 11.3(4)AA or a later release of Cisco IOS Release 11.3 AA
To prevent system problems, the VIP2 requires that the Cisco 7000 series router has the RSP7000
PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
Tools and Parts Required
3
Advertisement
Chapters
Table of Contents
