Table of Contents
Advertisement
VIP2 and the 5EFL Port Adapter
Step 11
Figure 12
Step 12
Step 13
Step 14
This completes the procedure for installing a new port adapter or replacing a port adapter on a VIP2.
16 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
Carefully slide the new port adapter into the port adapter slot until the connector on the
port adapter is completely mated with the connector on the motherboard.
Port Adapter Installed in a Port Adapter Slot (Partial Port Adapter View)
Replace the screw in the rear of the port adapter slot. (See Figure 9 for its location.) Do
not overtighten this screw.
Reinstall the VIP2 in the system. (Follow the steps in the section "Installing a VIP2" in
the configuration note Second-Generation Versatile Interface Processor (VIP2)
Installation and Configuration, which shipped with your VIP2.)
If disconnected, reconnect the interface cables to the port adapters.
Advertisement
Chapters
Table of Contents
