Table of Contents
Advertisement
Note
those same 10BASE-FL ports become 2/0/0 through 2/0/4 and 2/1/0 through 2/1/4.
Figure 14
5EFL in port adapter slot 0
(port numbers 3/0/0, 3/0/1, 3/0/2,
3/0/3, 3/0/4 from left to right)
You can identify interface ports by physically checking the slot/port adapter/interface port location
on the back of the router or by using show commands to display information about a specific
interface or all interfaces in the router.
Configuring Interfaces
The following steps describe a basic configuration. Press the Return key after each step unless
otherwise noted. At any time you can exit the privileged level and return to the user level by entering
disable at the prompt as follows:
Router# disable
Router>
Use the following procedure to perform a basic configuration:
Step 1
Step 2
If you remove the 5EFL-equipped VIP2 from slot 3 and install it in slot 2, the addresses of
10BASE-FL Interface Port Number Example (Cisco 7505 Shown)
At the privileged-level prompt, enter configuration mode and specify that the console
terminal will be the source of the configuration subcommands, as follows:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)#
At the prompt, specify the first interface to configure by entering the subcommand
interface, followed by the type (ethernet) and slot/port adapter/interface (interface
processor slot number). The example that follows is for the first interface of the first port
adapter, on a VIP2 in interface processor slot 1:
Router(config)# interface e 1/0/0
PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
5EFL in port adapter slot 1
(port numbers 3/1/0, 3/1/1, 3/1/2,
3/1/3, 3/1/4 from left to right)
End with CNTL/Z.
Configuring the 5EFL Interfaces
Slot 3
Interface
Slot 2
processor
Slot 1
slots
Slot 0
19
Advertisement
Chapters
Table of Contents
