SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Page 3
NEVER try to extinguish a fire with water, but switch off the • appliance and then cover flame e.g. with a lid or a fire blanket. CAUTION: The cooking process has to be supervised. A short • term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking •...
SAFETY INSTRUCTIONS plug (if applicable) can make the terminal This appliance is suitable for the following markets: become too hot. • Use the correct electricity mains cable. • Do not let the electricity mains cable tangle. INSTALLATION • Make sure that a shock protection is installed. •...
Page 5
• Make sure the flame does not go out when you quickly turn the knob from the maximum to the WARNING! Risk of injury, burns and minimum position. electric shock. • Use only the accessories supplied with the appliance. • Remove all the packaging, labelling and •...
• Disconnect the appliance from the mains • Flat the external gas pipes. supply. • Cut off the mains electrical cable close to the appliance and dispose of it. INSTALLATION WARNING! Refer to Safety chapters. BEFORE THE INSTALLATION Before you install the hob, write down the information bellow from the rating plate.
CONNECTION CABLE WARNING! When installation is To replace the connection cable use only the complete, make sure that the seal of special cable or its equivalent. The cable type is: each pipe fitting is correct. Use a H05V2V2-F T90. soapy solution, not a flame! Make sure that the cable section is applicable to the voltage and the working temperature.
CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit with door min 6 mm min 30 mm A) supplied seal...
PRODUCT DESCRIPTION COOKING SURFACE LAYOUT Rapid burner Semi-rapid burner Auxiliary burner Control knobs CONTROL KNOB Symbol Description Symbol Description minimum gas supply no gas supply / off position ignition position / maximum gas supply DAILY USE BURNER OVERVIEW WARNING! Refer to Safety chapters. A.
B. Burner crown CAUTION! In the absence of C. Ignition candle electricity you can ignite the burner D. Thermocouple without electrical device; in this case approach the burner with a flame, turn IGNITION OF THE BURNER the control knob counter-clockwise to maximum gas supply position and Always light the burner before you put push it down.
ENERGY SAVING • If it is possible, always put the lids on the Diameter of cook- Burner cookware. ware (mm) • When the liquid starts to boil, turn down the flame to barely simmer the liquid. Rapid 180 - 240 DIAMETERS OF COOKWARE Semi-rapid 120 - 220...
WHAT TO DO IF... Problem Possible cause Remedy There is no spark when you try The hob is not connected to an Check if the hob is correctly to activate the spark generator. electrical supply or it is con- connected to the electrical nected incorrectly.
C. Stick it on instruction booklet. TECHNICAL DATA HOB DIMENSIONS Width 590 mm Depth 510 mm OTHER TECHNICAL DATA TOTAL POW- Gas original: G30/G31 (3B/P) 30/30 mbar 498 g/h Electric supply: 220-240 V ~ 50-60 Hz Appliance cate- I3B/P gory: Gas connec- G 1/2"...
Page 14
Return the product to your local recycling facility or contact your municipal office.