SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Page 3
NEVER try to extinguish a fire with water, but switch off the • appliance and then cover flame e.g. with a lid or a fire blanket. CAUTION: The cooking process has to be supervised. A short • term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking •...
SAFETY INSTRUCTIONS plug (if applicable) can make the terminal This appliance is suitable for the following markets: become too hot. • Use the correct electricity mains cable. • Do not let the electricity mains cable tangle. INSTALLATION • Make sure that a shock protection is installed. •...
Page 5
• Make sure the flame does not go out when you quickly turn the knob from the maximum to the WARNING! Risk of injury, burns and minimum position. electric shock. • Use only the accessories supplied with the appliance. • Remove all the packaging, labelling and •...
• Disconnect the appliance from the mains • Flat the external gas pipes. supply. • Cut off the mains electrical cable close to the appliance and dispose of it. PRODUCT DESCRIPTION COOKING SURFACE LAYOUT Rapid burner Semi-rapid burner Auxiliary burner Control knobs CONTROL KNOB Symbol...
BURNER OVERVIEW WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute.
ENERGY SAVING WARNING! Do not put the same pan • If it is possible, always put the lids on the on two burners. cookware. • When the liquid starts to boil, turn down the WARNING! Do not put unstable or flame to barely simmer the liquid.
CLEANING THE SPARK PLUG PERIODIC MAINTENANCE This feature is obtained through a ceramic ignition Speak to your local Authorised Service Centre candle with a metal electrode. Keep these periodically to check the conditions of the gas components well clean to prevent difficult lighting supply pipe and the pressure adjuster, if fitted.
LABELS SUPPLIED WITH THE ACCESSORIES Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this part C.
Page 11
4. With a thin screwdriver, adjust the bypass screw position (A). WARNING! Make sure the flame does not go out when you quickly turn the knob from the maximum position to the A. End of shaft with nut minimum position. B.
ASSEMBLY min. 12 mm CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION Kitchen unit with door The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.
min 12 mm min. 30 mm min. min 5 mm 2 mm (max 150 mm) 60 mm A. Removable panel B. Space for connections Kitchen unit with oven The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
NORMAL POWER MINIMUM POW- NOMINAL GAS FLOW BURNER INJECTOR MARK ER kW Semi-rapid 0,56 Auxiliary 0,33 ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it.