hit counter script

Cisco FM4200 Installation And Configuration Manual page 64

Ultra-reliable wireless backhaul fiber
Hide thumbs Also See for FM4200:
Table of Contents

Advertisement

Figure 18. RACER™ Cloud connection info status (Connected)
Configure the unit using either of the following methods:
• To do a centralized (online) configuration of the unit using the FM
Racer interface, refer to the Cisco Networks FM Racer User
Manual.
• To do a local (offline) configuration using the Configurator interface,
refer to
"Device configuration using the configurator interface" (page
55).
If the unit is not able to connect to the internet:
• The unit will revert to a Fallback state.
• The unit's Status and link/boot LEDs will blink continuously from the
outer red and green to the inner green and orange. The LEDs will
repeat this cycle until the unit exits the Fallback state, or is set as
either Online or Offline.
• The unit's IP address will automatically be set to 192.168.0.10/24.
If the unit connects to the internet in Provisioning Mode, but cannot
connect to the Partners Portal, the unit's IP address will automatically be
set to 192.168.0.10/24. If the unit cannot connect to the Partners Portal,
verify that the Partners Portal can be reached by doing the following
steps:
1.
Check that the Ethernet cable leading to the unit is properly
connected.
2.
Check that the local DNS server can resolve
3.
Check that the local DNS server can resolve the IP address of
the FM Racer Cloud server, and that the address can be reached.
4.
Check the network firewall settings. Port 443 must be enabled.
5.
Click
this link.
• The Cisco Partners Portal page should open in your
browser.
6.
If the Partners Portal cannot be accessed, contact the Cisco
support desk by sending an E-mail to support@cisco.com.
7.
If the Partners Portal does not come back online, do a local
(offline) configuration using the Configurator interface. For further
information, refer to
interface" (page
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
"Device configuration using the configurator
55).
this address.
Page 64 of 189

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fm4500 fiberFm1000Fm1200 voloFm3200 baseFm3500 endoFm4200 fiber ... Show all

Table of Contents