Cisco Nexus 93120TX Installation Manual page 34

Nx-os mode switch hardware

Hide thumbs Also See for Nexus 93120TX:

Table of Contents

Installing the Chassis in a Four-Post Rack

If the bottom support rails are extended a long distance, they can bend outwards slightly when you install the

Note

chassis and the chassis stops at the far end of the rails might not fit into the end of the chassis. If this happens,

press the side rails toward the sides of the chassis so that the chassis stops can go inside the chassis and hold it

in place on the rack.

Figure 8: Sliding the Chassis onto the Bottom-Support Rails

Slide the power-supply end of the chassis onto the

bottom-support rails so that the chassis locks onto the

chassis stops at the end of the rails.

Chassis stops for holding the chassis (positioned by

the aisle required for the fan and power supply

modules).

Cisco Nexus 93120TX NX-OS Mode Switch Hardware Installation Guide

Receiving hole on each side of the chassis for the

chassis stops on the bottom-support rails.

Customer-supplied rack-mount screw (M6 x 10 mm

screw or other screw appropriate for the rack) used

to secure each side of the chassis to the rack.

Installing the Chassis

Table of Contents