Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZWT10710W
Summary of Contents for Zanussi ZWT10710W
- Page 1 User Manual GETTING STARTED? EASY. ZWT10710W ZWT10710S Washing Machine...
-
Page 2: Safety Information
VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. -
Page 3: Safety Instructions
- staff kitchen areas in shops, offices and other working environments. - by clients in hotels, motels, bed & breakfast and other residential type environments. - areas for communal use in blocks of flats or in launderettes. The operating water pressure at the water entry point from the •... -
Page 4: Electrical Connection
– Handle the machine carefully. Never hold • Before washing the clothes at first time, the each protruded part on the machine while product shall be operated in one round of the lifting. Machine door can not be used as the whole procedures without the clothes inside handle during the conveyance. -
Page 5: Installation Area
• Cut off the mains electrical cable close to the • Dispose of the appliance in accordance with appliance and dispose of it. local requirements for the disposal of Waste • Remove the door catch to prevent children or Electrical and Electronic Equipment (WEEE). pets from becoming trapped in the drum. -
Page 6: Levelling The Washing Machine
LEVELLING THE WASHING MACHINE WARNING! The lock nuts on feet After being locked prop- must be screwed tightly against the erly, press four corners housing. again to make sure that they has been adjusted A. lock properly. B. Lower C. Raise D. -
Page 7: Product Description
PRODUCT DESCRIPTION APPLIANCE OVERVIEW Top lid Control panel Water inlet valve "cold & hot" Adjustable foot knob Power case and plug Cabinet Handle Frame Drain hose ACCESSORIES 1. Inlet hose 2. Cabinet baseboard 3. User manual... -
Page 8: Control Panel Description
4. Screw 5. Spring clamper 6. drain hose 1) If the drain hose is already installed on the machine, then there is no spring clamper and drain hose in the accessories. CONTROL PANEL CONTROL PANEL DESCRIPTION المياه مستوي الحلة تنظيف الغاء... -
Page 9: Programme Chart
PROGRAMMES PROGRAMME CHART Programme Programme description Regular اعتيادي Standard fabric washing program, suitable to wash regular cotton fab- ric. One Wash cycle, two rinsing cycles, longer spin time. ناعمة أقمشة Delicates Mid/high/low water level selection, soft slow washing and spinning speed, to reduce clothes deformation. -
Page 10: Daily Use
DAILY USE AVAILABLE OPTIONS FOR WASHING For available options for washing: One Touch Smart Wash 1. Switch power on. 2. Start wash. For selecting program for washing 1. Switch power on. 2. Select program. 3. Select water level. 4. Start wash. Personalized setting of washing program 1. -
Page 11: Stubborn Stains
• Turn multilayered fabrics, wool and items with – powder detergents for all types of fabric, painted illustrations inside out. – powder detergents for delicate fabrics • Remove hard stains with a special detergent. (40 °C max) and woollens, • Wash and pre-treat heavy soil stains before –... -
Page 12: Cleaning The Inlet Filter
CLEANING THE INLET FILTER CLEANING DRAIN PUMP FILTER Inlet filter must be cleaned if there is WARNING! • Be careful of the hot less water. water! • Allow detergent solution to cool down. To clean the inlet hose follow the following steps: •... -
Page 13: Troubleshooting
WARNING! • Make sure that valve cap and emergency drain hose are reinstalled properly, cap plates should 5. Restore it and adjust be inserted aligning to hole plates the convex place to align otherwise water may leak. at the pump hole. •... -
Page 14: Technical Data
Problems without alarm messages Description Inspection Items The appliance is not washing If the power is off or the fuse is burned out. If the power supply voltage is too low. If the water amount reaches to the required water level.(The washer will not work if the water amount does not reach the re- quired water level) If it is set to "Delay"... -
Page 15: Environmental Concerns
Spin speed Maximum 700 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. - Page 16 WWW.ZANUSSI.COM/SHOP...
- Page 17 WWW.ZANUSSI.COM/SHOP...
- Page 27 >0mm...
- Page 28 < 1000 mm > 860 mm < 1000 mm > 860 mm...
-
Page 32: Getting Started
User Manual GETTING STARTED? EASY.