Table of Contents
Advertisement
CAUTION
●
Be sure to securely tighten the screw
with the screwdriver, otherwise the
needle may touch the presser foot,
causing it to bend or break.
●
Before starting to sew, slowly turn the
balance wheel toward you and check
that the needle does not touch the
presser foot. If the needle hits the presser
foot, the needle may bend or break.
Note
● When sewing with the walking foot, sew at
a speed between slow and medium.
■ Removing the walking foot
Press
(needle position button) once or
1
twice to raise the needle.
1 Needle position button
The needle is raised.
2
Turn off the sewing machine.
1
Raise the presser foot lever.
3
1 Presser foot lever
The presser foot is raised.
With a screwdriver, loosen the presser foot
4
holder screw, and then remove the walking
foot.
Attach the presser foot holder.
5
• For details, refer to "Removing the presser
foot holder" (page 39).
Memo
● Only the straight stitch (with reinforcement
stitching) and the zigzag stitch can be used
with the walking foot. For details on the
stitches, refer to "Stitch Settings" (page 128).
Replacing the Presser Foot
1
41
Hide quick links:
Advertisement
Table of Contents
