Table of Contents
Advertisement
CAUTION
●
Be sure to cut the thread as described on
the previous page. If the bobbin is wound
without cutting the thread using the
cutter built into the slit in the bobbin
winder seat, the thread may become
tangled in the bobbin or the needle may
bend or break when the bobbin thread
starts to run out.
Slide the sewing speed controller to the right
c
(so that the speed will be fast).
1 Sewing speed controller
d
Press
(start/stop button) once.
1
1 Start/stop button
The bobbin starts spinning and the thread is
wound around the bobbin.
The bobbin stops spinning when it is full.
e
Press
(start/stop button) once.
The sewing machine stops.
f
g
h
1
i
Use scissors to cut the end of the thread
wound around the bobbin.
Slide the bobbin winder shaft to the left.
Remove the bobbin from the shaft.
Slide the sewing speed controller back to its
original position.
CAUTION
●
Use a bobbin thread that has been
correctly wound, otherwise the needle
may break or the thread tension will be
incorrect.
Memo
● When the sewing machine is started or the
balance wheel is turned after winding the
thread around the bobbin, the machine will
make a clicking sound; this is not a
malfunction.
Winding/Installing the Bobbin
21
Hide quick links:
Advertisement
Table of Contents
