Configure The Xr Vm Management Port - Cisco NCS 6008 Series Manual
Hide thumbs
Also See for NCS 6008 Series:
- Unpacking, moving, and securing manual (44 pages) ,
- Unpacking, moving, and securing manual (52 pages)
Advertisement
Bring-up the Cisco NCS 6008 Router
Step 4
config
Example:
sysadmin-vm:0_RP0#config
Enters System Admin Config mode.
Step 5
(Optional) exit
Example:
sysadmin-vm:0_RP0#exit
Return to the XR VM CLI from the System Admin VM CLI.
Alternate Method to Access the System Admin VM
Instead of executing the admin command, you can access the System Admin prompt by directly
connecting to the System Admin VM console port. Console port 1 on the RP is for System Admin
VM. While connecting to the System Admin VM console port, enter the System Admin username
and password, when prompted. For more details about System Admin VM username and password,
see the chapter
Important
It is not possible to access the XR VM through the System Admin VM console port.
Configure the XR VM Management Port
To use the XR VM Management port for system management and remote communication, you must configure
an IP address and a subnet mask for the management ethernet interface. To communicate with devices on
other networks (such as remote management stations or TFTP servers), you need to configure a default (static)
route for the router .
Before you begin
• Consult your network administrator or system planner to procure IP addresses and a subnet mask for the
• Physical port Ethernet 0 on RP is the management port. Ensure that the port is connected to management
SUMMARY STEPS
1. configure
2. interface MgmtEth rack/slot/CPU0/port
3. ipv4 address ipv4-address subnet-mask
4. ipv4 address ipv4 virtual address subnet-mask
5. no shutdown
Create User Profiles and Assign
management interface.
network.
Configure the XR VM Management Port
Privileges.
Bring-up the Cisco NCS 6008 Router
5
Hide quick links:
Advertisement
