Preparing Reel For Grinding - Toro Reelmaster 6500–D Service Manual
Hide thumbs
Also See for Reelmaster 6500–D:
- Service manual (328 pages) ,
- Quick service reference (258 pages) ,
- Operator's manual (48 pages)
Table of Contents
Advertisement
Preparing Reel for Grinding
1. Check to make sure reel bearings are in good condi-
tion and properly adjusted before grinding the reel.
Make sure the cutting unit frame and roller brackets are
true and not bent or damaged from impacts with trees,
posts or cart path edges.
2. Remove bedbar assembly.
3. Remove parts as necessary to mount the cutting unit
in the grinder (e.g. front roller, brackets). Follow the
ginding equipment manufactuer's instructions for
mounting the cutting unit.
Note: The cutting unit must be aligned so the grinding
wheel will travel parallel to the reel shaft. This will result
in the the reel being ground to the desired cylinder
shape.
REEL DIAMETER
BLADE
LAND
WIDTH
Cutting Units
Model 03853
Model 03854
Model 03855
D
1
REEL DIAMETER TAPER = D
Page 7 – 16
Note: When grinding, be careful to not overheat the reel
blades. Remove small amounts of material with each
pass of the grinder.
4. After completing the grinding process, do a complete
set–up and adjustment procedure.
Reel Grinding Specifications
Nominal Reel Diameter
Service Limit Reel Diameter
Blade Relief Angle
Relief Angle Range
Blade Land Width
Land Width Range
Service Limit Reel Taper
BLADE RELIEF ANGLE
– D
1
2
Figure 23
Rev. B
7I (178 mm)
6.2I (158 mm)
30_
20_ – 40_
.060I (1.5 mm)
.050I – .090I (1.3 – 2.3 mm)
.060I (1.5 mm)
D
2
Reelmaster 6500–D/6700–D
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
