Control Sip And Rtp Behaviour In Dual Mode - Cisco 8800 Series Manual
Hide thumbs
Also See for 8800 Series:
- Administration manual (406 pages) ,
- User manual (218 pages) ,
- Hardware installation manual (140 pages)
Table of Contents
Advertisement
Control SIP and RTP Behaviour in Dual Mode
Parameter
RTP Before ACK
Control SIP and RTP Behaviour in Dual Mode
You can control SIP and RTP parameters with SIP IP Preference and SDP IP Preference fields when phone
is in dual mode.
SIP IP Preference parameter defines which IP address phone tries first when it is in dual mode.
Table 74: SIP IP Preference and IP Mode
IP Mode
Dual
Mode
Dual
Mode
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
358
SIP IP
Address List from DNS, Priority, Result
Preference
P1 - First Priority Address
P2 - Second Priority Address
IPv4
P1- 1.1.1.1, 2009:1:1:1::1
P2 - 2.2.2.2, 2009:2:2:2::2
Result: Phone will send the SIP messages to 1.1.1.1
first.
IPv6
P1- 1.1.1.1, 2009:1:1:1::1
P2 - 2.2.2.2, 2009:2:2:2::2
Result: Phone will send the SIP messages to
2009:1:1:1::1 first.
Description
Allows you to specify whether an RTP session starts
before or after an ACK is received from the calling
party.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<RTP_Before_ACK
ua="na">No</RTP_Before_ACK>
• In the phone web page select:
• Yes: An RTP session doesn't await an ACK,
but starts after a 200 OK message is sent.
• No: An RTP session doesn't start until an
ACK is received from the calling party.
Allowed values: Yes or No
Default: No
Failover Sequence
1.1.1.1 ->2009:1:1:1:1 ->
2.2.2.2 -> 2009:2:2:2:2
2009:1:1:1:1 ->
1.1.1.1 -> 2009:2:2:2:2 ->
2.2.2.2
Cisco IP Phone Installation
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
