Cisco Aironet 1520 Series Hardware Installation Manual page 36
Hide thumbs
Also See for Aironet 1520 Series:
- Mounting instructions (70 pages) ,
- Hardware installation manual (50 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Mounting the Access Point
Step 4
Position the two bolts on the access point into the quick mount notches on each side of the mounting
bracket (see
Figure 2-8
Step 5
Screw a M8 x16 bolt (with flat and lock washers) into the second bolt hole on each side of the access
point.
Step 6
Ensure that the front of the access point is vertical, and tighten the four bolts to 13 to 15 ft lbs
(17.6 to 20.3 Nm).
Step 7
(Optional) When using the optional Cisco external omnidirectional antennas, connect them to the access
point as shown in
Note
Continue with the
Step 8
Point" section on page
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-20
Figure
2-8). Ensure that the hinged door is facing out.
Access Point Hanging in Mounting Bracket
Figure
2-2. Hand-tighten the antennas to the access point.
Some access point configurations might support two or three of the 2.4-GHz antennas.
"Grounding the Access Point" section on page 2-42
2-46.
Chapter 2
Mounting Instructions
and the
"Powering the Access
OL-12632-02
Hide quick links:
Advertisement
Table of Contents
