Mounting The Access Point; Statement - Cisco Aironet 1520 Series Hardware Installation Manual
Hide thumbs
Also See for Aironet 1520 Series:
- Mounting instructions (70 pages) ,
- Hardware installation manual (50 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Mounting the Access Point
To configure the BGN for the access points using the GUI, follow these steps:
Step 1
Log into your controller using a web browser.
Step 2
Click Wireless. When access points associates to the controller, the access point's name appears in the
AP Name list.
Step 3
Double-click on an access point's name.
Step 4
Find Mesh Information, and enter the new BGN in the Bridge Group Name field.
Step 5
Click Apply.
Step 6
Repeat Steps 2 through 5 for each access point.
Step 7
Log out from your controller, and close your web browser.
Mounting the Access Point
This section provides instructions for installing your access points. Personnel installing the access point
must understand wireless access points and bridging techniques and grounding methods.
Caution
All mounting methods on any wall surface is subject to the acceptance of local jurisdiction.
Installation Options
There are two optional installation kits:
•
•
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Caution
To provide inline PoE, you must use the power injector (AIR- PWRINJ1500-2=) specified for the access
point. Other power injectors, PoE switches, and 802.3af power sources do not provide adequate power,
which might cause the access point to malfunction and cause over-current conditions at the power
source. You must ensure that the switch port connected to the access point has PoE turned off.
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-16
Pole mount kit—used for pole, wall, or streetlight installations
Strand mount kit—used for cable strand installations
Chapter 2
Mounting Instructions
OL-12632-02
Hide quick links:
Advertisement
Table of Contents
