Table of Contents
Advertisement
Installing the UC 320W and Phones
Installing the Phone
NOTE
STEP 1
STEP 2
Unified Communications UC 320W Administration Guide
5. Phone port: Use this port to connect the phone cord for the handset. Connect
the other end of the phone cord into port on the bottom of the handset (not
shown).
6. Power port: Use this port to connect the supplied power cord.
NOTE: This phone can receive power over Ethernet only if a Cisco POES5 5-Volt
Power Over Ethernet Splitter accessory is connected.
Installing a Desk Stand (Optional)
A desk stand is provided with each Cisco IP phone. The stand can be easily
attached or removed.
•
Do not attach the desk stand if you want to mount the phone to the wall. See
Mounting a Phone to a Wall (Optional), page
•
If you plan to attach a Cisco SPA 500S attendant console, attach it before
attaching the desk stand. See
Connect the phone stand by lining up the tabs on the stand with the slots on the
phone body.
Slide the bottom tabs into the lower slots on the phone body and lightly press
down on the stand. It should easily slide into the upper stand slots. Do not force.
23.
Connecting Attendant Consoles, page
1
33.
22
Advertisement
Table of Contents
