Table of Contents
Advertisement
Installing the Supervisor in the Cisco cBR Chassis
What to Do Next
• If you are using a single Supervisor Card,
•
•
Using the SFP+ Ports on the Supervisor PIC
Before You Begin
•
•
•
• Do not remove the protective dust plugs on the unplugged fiber-optic cable connectors and the SFP+
Required Tools and Equipment
• Fiber-optic cable with the LC connector
Step 1
Remove the dust plugs from the network interface cable LC connectors. Save the dust plugs for future use.
Step 2
Inspect and clean the LC connector
Step 3
Remove the dust plug from the SFP+ module optical bores on the Supervisor PIC.
Step 4
Immediately connect the fiber-optic cable with cable LC connector to the SFP+ port.
Grasp the LC connector housing to connect the fiber-optic cable to the SFP+
Important
ports.
Figure 37: LC fiber-optic connector
What to Do Next
Route the fiber-optic cables through the Supervisor PIC cable management bracket and chassis-mounted fiber/
cable routing
Connect memory stick or flash drive to use the USB port
Connect cable to use the console port
Install the Supervisor
PIC.
Install the SFP+ module in the Supervisor PIC
Install the Supervisor
Card.
optical bores until you are ready to make a connection.
end-faces.
guide.
Using the SFP+ Ports on the Supervisor PIC
install a blank card for the Supervisor
(if required).
(if required).
Cisco Converged Broadband Routers Hardware Installation Guide
in the empty slot.
49
Advertisement
Table of Contents
