Table of Contents
Advertisement
Installing the Supervisor in the Cisco cBR Chassis
• PC or terminal
Step 1
Open the tethered I/O door on the Supervisor Card by pulling on the left edge of the door until the door is released from
the spring-loaded ejector.
Figure 26: Opening the Tethered I/O Door on the Supervisor Card
1
Tethered I/O door
Step 2
Connect the mini type-B USB connector of the console cable to the console port on the Supervisor Card.
Figure 27: Console Port Connection on the Supervisor Card
1
Mini type-B USB connector
Using the Console Port on the Supervisor Card
—
2
Console cable (with mini type-B USB connector
on one end, and a type-A USB connector on the
other end)
Cisco Converged Broadband Routers Hardware Installation Guide
29
Advertisement
Table of Contents
