Attaching the Optical Network Cable
What to Do Next
• If you are using a single Supervisor Card,
•
•
Attaching the Optical Network Cable
Before You Begin
•
•
•
Before removing the dust plugs and making any optical connections, follow these guidelines:
• Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the transceiver
• Inspect and clean the MPO connector end faces just before you make any connections.
• Grasp the MPO connector only by the housing to plug or unplug a fiber-optic cable.
40-Gigabit QSFP+ or QSFP28 transceiver modules are keyed to prevent incorrect insertion.
Note
Cisco Converged Broadband Routers Hardware Installation Guide
14
Connect memory stick or flash drive to use the USB port
Connect cable to use the console port
Install the Supervisor
PIC.
Install the QSFP+ or QSFP28 module in the Supervisor PIC
Install the Supervisor
Card.
optical bores until you are ready to make a connection.
Installing the Supervisor in the Cisco cBR Chassis
install a blank card for the Supervisor
(if required).
(if required).
in the empty slot.