Table of Contents
Advertisement
Installing the SFP+ Modules in the Supervisor PIC
Note
Do not remove the optical bore dust
plugs.
Figure 31: SFP+ Module with Dust Plugs
1
Dust plug
2
Bail clasp with clasp tab
Step 2
Check the label on the SFP+ module to verify that you have the correct model for your network.
Step 3
Find the send (TX) and receive (RX) markings that identify the top side of the SFP+ module.
On some SFP modules, the TX and RX marking might be replaced by arrowheads pointing from the SFP+
Note
module connector (transmit direction or TX) and towards the connector (receive direction or RX).
Step 4
Align the SFP+ module in front of the socket opening.
Step 5
Carefully insert the SFP+ module into the socket until you feel the connector latch into place.
Figure 32: Installing the SFP+ Module in the Supervisor PIC
Cisco Converged Broadband Routers Hardware Installation Guide
44
Installing the Supervisor in the Cisco cBR Chassis
3
Transmit bore
4
Receive bore
Advertisement
Table of Contents
