Cisco cBR Hardware Installation Manual page 61

Converged broadband routers

Hide thumbs Also See for cBR:

Table of Contents

Installing the Supervisor in the Cisco cBR Chassis

Restrictions

The USB ports on the Supervisor Card are used for temporary connections. For all permanent connections,

you must use the ports on the Supervisor PIC.

Required Tools and Equipment

• Memory stick or flash drive

Step 1

Open the tethered I/O door on the Supervisor Card by pulling on the left edge of the door until the door is released from

the spring-loaded ejector.

Figure 50: Opening the Tethered I/O Door on the Supervisor Card

Tethered I/O door

Step 2

Connect the memory stick or flash drive to the USB port on the Supervisor Card.

Figure 51: Connecting the USB Drive to the USB Port

Using the USB Port on the Supervisor Card

—

Cisco Converged Broadband Routers Hardware Installation Guide

Table of Contents