Cisco cBR Hardware Installation Manual page 57

Converged broadband routers

Hide thumbs Also See for cBR:

Table of Contents

Installing the Supervisor in the Cisco cBR Chassis

Figure 46: Routing the Fiber-Optic Cables Connected to the Supervisor PIC — Option 3

Strap-down clip

Fiber-optic cable bundle in flexible conduit

Step 2

Perform the following for the RJ-45 cables connected to the Supervisor PIC:

• If you are using a chassis-mounted snap-on plastic fiber/cable routing guide, route the RJ-45 cables through the

lower slot of the snap-on plastic fiber/cable routing guide and then through the lower slot of the Supervisor PIC

cable management bracket. Secure the cable bundle using cable ties.

• If you are using a chassis-mounted cable strap-down clip without the snap-on plastic fiber/cable routing guide,

route the RJ-45 cables through the lower slot of the Supervisor PIC cable management bracket. Secure the cable

bundle to the lower tie down point on the strap-down clip using a cable tie.

Cable Management for the Supervisor PIC in the Cisco cBR Chassis

Cable tie

Supervisor PIC cable management bracket

Cisco Converged Broadband Routers Hardware Installation Guide

Table of Contents