Table of Contents
Advertisement
Using the Console Port on the Supervisor PIC
• PC or terminal
Step 1
Connect one end of the RJ-45 cable to the console port on the Supervisor PIC.
Figure 40: Console Port Connection on the Supervisor PIC
Step 2
Connect the other end of the RJ-45 cable to the RJ-45-to-DB-9 adapter.
Figure 41: Connecting an RJ-45-to-DB-9 Adapter
Step 3
Connect the RJ-45-to-DB-9 adapter to the appropriate serial port on the PC or terminal.
Step 4
Power up the PC or terminal.
Step 5
Configure the PC terminal emulation software or the terminal with the following settings:
• 9600 baud
• 8 data bits
• No parity generation or checking
• 1 stop bit
• No flow control
What to Do Next
•
Cisco Converged Broadband Routers Hardware Installation Guide
52
Route the cable through the Supervisor PIC cable management bracket and chassis-mounted fiber/cable
routing
guide.
Installing the Supervisor in the Cisco cBR Chassis
Advertisement
Table of Contents
