Table of Contents
Advertisement
Installing the Supervisor in the Cisco cBR Chassis
• ESD-preventive wrist strap
• Supervisor PIC
• Supervisor PIC cable management bracket
• 3/16" flat-blade torque screwdriver
Step 1
Align the captive screws on the Supervisor PIC cable management bracket with the mounting holes on the Supervisor
PIC.
Ensure that the lower slot in the cable management bracket is the smaller slot for fiber-optic cables and the
Important
upper slot is the larger slot for RJ-45 cables.
Figure 3: Installing the Supervisor PIC Cable Management Bracket
1
Captive screws
Step 2
Tighten the captive screws using a 3/16" flat-blade torque screwdriver with a torque of 6-8 in-lb (0.68-0.90 Nm) to secure
the Supervisor PIC cable management bracket.
What to Do Next
•
•
Install the chassis-mounted fiber/cable routing guide
Route the Supervisor PIC cables through the Supervisor PIC cable management bracket and
chassis-mounted fiber/cable routing
Installing the Supervisor PIC Cable Management Bracket
2
Supervisor PIC cable management bracket
(if not already installed).
guide.
Cisco Converged Broadband Routers Hardware Installation Guide
5
Advertisement
Table of Contents
