Table of Contents
Advertisement
Using the Console Port on the Supervisor Card
Step 2
Connect the memory stick or flash drive to the USB port on the Supervisor Card.
Figure 25: Connecting the USB Drive to the USB Port
Using the Console Port on the Supervisor Card
Before You Begin
•
•
Restrictions
• When running a redundant configuration in the chassis, each Supervisor Card or Supervisor PIC must
• The console port on the Supervisor Card is for temporary connections. For permanent console connection,
Required Tools and Equipment
• Console cable (with mini type-B USB connector on one end, and a type-A USB connector on the other
• Exar XR21V1410 UART with USB interface
• Cable with type-A USB connector on one end and DB-9 connector on the other end
Cisco Converged Broadband Routers Hardware Installation Guide
28
Install the Supervisor
PIC.
Install the Supervisor
Card.
have a console port connection.
you must use the port on the Supervisor PIC.
end)
Installing the Supervisor in the Cisco cBR Chassis
Advertisement
Table of Contents
