Cisco cBR Hardware Installation Manual page 10

Converged broadband routers

Hide thumbs Also See for cBR:

Table of Contents

Installing the Supervisor Card in the Cisco cBR Chassis

• Supervisor Card

• Blank card for the Supervisor

Before You Begin

If you are adding a new Supervisor Card or upgrading the existing Supervisor Cards, ensure that the power

Warning

modules installed in the chassis are adequate to support the Supervisor Cards.

• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug

connected to the chassis.

•

Install the Supervisor PIC

• Be aware of the weight and size of the equipment. Handle it with care.

Restrictions

• If you are using a single Supervisor, you must install the Supervisor Card in the slot corresponding to

the Supervisor PIC.

Note

Required Tools and Equipment

• ESD-preventive wrist strap

• Supervisor Card or blank card for the Supervisor

Cisco Converged Broadband Routers Hardware Installation Guide

(recommended).

In the Cisco cBR-8 router,

• Slot 4/1 for the Supervisor PIC corresponds to slot SUP0 for the Supervisor Card.

• Slot 5/1 for the Supervisor PIC corresponds to slot SUP1 for the Supervisor Card.

Installing the Supervisor in the Cisco cBR Chassis

Table of Contents