Pioneer XM2GO User Manual page 13

Portable satellite radio with mp3

Hide thumbs Also See for XM2GO:

Table of Contents

Using Your inno Alone

4. To install the swivel mount, first find a suitable location. The swivel mount's adhesive is

very strong and may be difficult to remove. Do not install this mount on leather surfaces

and make sure the air temperature is at least 60°F (15°C).

Clean the mounting surfaces with the surface preparation kit. Peel away the adhesive liner

and firmly press the swivel mount to the surface for 30 seconds. Allow 24 hours before

using the mount.

If you need to remove the mount, carefully lift the adhesive pad with your fingers or a

spoon. Warming with a hair dryer for several minutes will help soften the adhesive.

Using Your inno Alone

You can adjust the tension of

the mount with a screwdriver.

Using Your inno Alone

5. To install the vent mount, find a horizontal vent that is strong enough to hold your inno

and dock. To remove the vent mount, push it into the vent and lift upwards slightly to

release the mount's hooks from the vent vane.

6. Find an unused FM frequency on your car stereo.

7. Set your inno to the same FM frequency. (Refer to the section marked "Settings," "FM

Frequency.")

8. Tune inno to XM channel 1. You should be able to hear XM through your car stereo.

Using Your inno Alone

Table of Contents

Show Quick Links

Table of Contents

Gexinno1 - inno 1 gb xm radio tuner