Table of Contents
Advertisement
Using External Equipment
12
Making network connections
To connect to a network, set up the Home Media Gallery
through the panel's menu. Connect to a home network (LAN)
via an Ethernet hub or cable directly to a media server.
NOTE
• Although the Home Media Gallery supports 10BASE-T, it is
better to use 100BASE-TX for improved display quality and
speed.
Connecting via an Ethernet hub
If you already operate one or more media servers on a local
area network (LAN), connect the Plasma Display to the
Ethernet (LAN) hub using a standard ("straight-through")
Ethernet (LAN) cable. See the diagram below.
Media Server 2
Ethernet Hub
(Router with hub function)
Media Server 1
Connecting directly to a Media Server
To run a PC as a media server, connect the Plasma Display
directly to the PC using a twisted ("cross-over") Ethernet (LAN)
cable. See the diagram below.
Plasma Display
(rear view)
76
En
Plasma Display
(rear view)
Viewed from the
bottom of the
Plasma Display
Straight-through
Cable
Viewed from the
bottom of the
Plasma Display
Cross-over Cable
Media Server 1
Confirming the IP Address
After making the network connection, follow the instructions
below to confirm the panel's IP Address before accessing the
network. (The setup is effective for "Auto" only. To perform the
procedure, DHCP on your server or router must be valid.)
1
Press HOME MENU.
2
Select "Home Media Gallery" (
3
then ENTER).
Select "Setup" (
/
4
Select "Network Setup" (
5
Select "Automatically acquire IP" (
ENTER).
• The screen turns from "Select" mode to "Input" mode.
6
then ENTER).
Select "Yes" ( /
• The IP Address is automatically assigned.
• The Home Media Gallery supports Auto IP and DHCP
(Dynamic Host Configuration Protocol). If the system
failed to acquire the IP Address or if you want to obtain
different addresses, select "No" then enter "IP Address"
and "Subnet mask". Use the 0 to 9 and
buttons to enter an address, then press ENTER. You do
not need to enter "Default Gateway" and "DNS Server".
7
then ENTER).
Select "OK" ( /
• The "Reset" dialog appears on screen.
8
Select "OK" and press ENTER.
• The home network module restarts.
• A message "Setting up Home Media Gallery. Please wait
until initialized." appears on screen.
• When the initialization is finished, setting values
become effective and the top menu of the Home Media
Gallery returns.
NOTE
• For information on DHCP, refer to network device's
operating instructions.
• You may need to contact your service provider or network
administrator when manually entering an IP Address.
• Some media servers block or are programmed to block
access to client servers. When connecting the Plasma
Display, check the media server for client server access
rights.
Connecting a USB device
You can also enjoy content stored on memory cards by
connecting a USB device to the Plasma Display. When you
insert a USB memory or multi-card reader into the USB port,
the root directory or the Device List screen appears. In addition,
you can connect your digital camera directly to the Plasma
Display using a USB connector cable.
1
Press HOME MENU.
2
Select "Home Media Gallery" (
3
then ENTER).
Select "USB" (
/
• The Device List is displayed on screen with the selected
device highlighted if you have not checked in the "Single
Server/USB" box after selecting "Setup" and then "Auto
Connection Setup". If you have checked in the box, the
list is skipped.
then ENTER).
/
then ENTER).
/
/
/ /
then
/ / /
then ENTER).
/
- Quick Links:
- Remote Control Unit
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
