Table of Contents
Advertisement
Preparation
Connecting the power cord
Connect the power cord last, after all other components are connected.
Plasma Display (rear view)
CAUTION
• Use only the supplied power cord.
• Use only the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power
cord with a ground terminal is used for safety
reasons. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.
Routing cables
When the speakers are installed on the sides
Rear view
Speaker cable
Attaching speed clamps to the main unit
Attach the speed clamps using any of the 4 holes you prefer
(50 inches, 3 holes: 42 inches, 2 holes) marked with an arrow ( )
below, depending on your routing system.
for PRO-1540HD
for PRO-1140HD
for PRO-940HD
Speed clamp
Power cord
NOTE
• Always turn the panel's power OFF when connecting or
disconnecting power cords.
• Disconnect the power cord from the wall outlet when the
Plasma Display Panel is not going to be used for a long
period of time.
Speed clamp
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the Plasma
Display then snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to release once in
place. Please attach them carefully.
Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
2
1
NOTE
• Use the supplied speed clamps as necessary.
• Bundle speaker cables so that none are pinched.
AC IN terminal is
located on the upper
edge of the
compartment.
Noise filter
Partially eliminates noise
caused by the power source.
Speaker cable
05
25
En
- Quick Links:
- Remote Control Unit
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
