Understanding The Boot Process - Cisco 3032 Software Configuration Manual

Hide thumbs Also See for 3032:

Table of Contents

Assigning the Switch IP Address and Default

This chapter describes how to create the initial switch configuration (for example, assigning the IP

address and default gateway information) by using a variety of automatic and manual methods. It also

describes how to modify the switch startup configuration. Unless otherwise noted, the term switch refers

to a standalone switch and to a switch stack.

For complete syntax and usage information for the commands used in this chapter, see the command

reference for this release and the Cisco IOS IP Command Reference, Volume 1 of 3: Addressing and

Services, Release 12.2.

This chapter consists of these sections:

Information in this chapter about configuring IP addresses and DHCP is specific to IP Version 4 (IPv4).

If you plan to enable IP Version 6 (IPv6) forwarding on your switch, see

Unicast Routing"

stack or switch must be running the IP services feature set.

Understanding the Boot Process

To start your switch, you need to follow the procedures in the hardware installation guide for installing

and powering on the switch and setting up the initial switch configuration (IP address, subnet mask,

default gateway, secret and Telnet passwords, and so forth).

Understanding the Boot Process, page 3-1

Assigning Switch Information, page 3-2

Checking and Saving the Running Configuration, page 3-16

Modifying the Startup Configuration, page 3-17

Scheduling a Reload of the Software Image, page 3-22

for information specific to IPv6 address format and configuration. To enable IPv6, the

Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide

C H A P T E R

Chapter 39, "Configuring IPv6

Table of Contents