Table of Contents
Advertisement
Configuring SNMP
Command
Step 3
snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Step 4
snmp-server group groupname {v1 |
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
Step 5
snmp-server host host-addr
[informs | traps] [version {1 | 2c | 3
{auth | noauth | priv}}]
community-string [notification-type]
Step 6
snmp-server enable traps
notification-types
Step 7
snmp-server trap-source interface-id
Step 8
snmp-server queue-length length
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
33-14
Purpose
Configure an SNMP user to be associated with the remote host created in
Step 2.
Note
You cannot configure a remote user for an address without first
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Configure an SNMP group.
Specify the recipient of an SNMP trap operation.
For host-addr, specify the name or Internet address of the host (the
•
targeted recipient).
(Optional) Enter informs to send SNMP informs to the host.
•
•
(Optional) Enter traps (the default) to send SNMP traps to the host.
(Optional) Specify the SNMP version (1, 2c, or 3). SNMPv1 does
•
not support informs.
(Optional) For Version 3, select authentication level auth, noauth,
•
or priv.
Note
The priv keyword is available only when the cryptographic
universal software image is installed.
For community-string, when version 1 or version 2c is specified,
•
enter the password-like community string sent with the notification
operation. When version 3 is specified, enter the SNMPv3 username.
(Optional) For notification-type, use the keywords listed in
•
Table 33-5 on page
33-12. If no type is specified, all notifications are
sent.
Enable the switch to send traps or informs and specify the type of
notifications to be sent. For a list of notification types, see
page
33-12, or enter snmp-server enable traps ?
To enable multiple types of traps, you must enter a separate snmp-server
enable traps command for each trap type.
When you configure a trap by using the notification type
Note
port-security, configure the port security trap first, and then
configure the port security trap rate:
snmp-server enable traps port-security
•
snmp-server enable traps port-security trap-rate rate
•
(Optional) Specify the source interface, which provides the IP address for
the trap message. This command also sets the source IP address for
informs.
(Optional) Establish the message queue length for each trap host. The
range is 1 to 1000; the default is 10.
Chapter 33
Configuring SNMP
Table 33-5 on
OL-12247-04
Advertisement
Chapters
Table of Contents
Troubleshooting
